Harman-Kardon HKTS11 owner manual

SUB-TS11 SUBWOOFER AMPLIFIER PANEL CONTROLS AND CONNECTIONS

					SUBWOOFER
					LEVEL
¡				FILTER
			ON			MAX
™			OFF		MIN
£
¢						PHASE
					REVERSE
∞
					NORMAL
§
			SUB		R	L
		LINE
		LEVEL
¶		IN
	H	L
	I
	G
	H
•	L
	E
	V
	E	R
	L
ª			OUT			IN
‚
			IMPORTANT: CONNECT STRIPED WIRE
⁄			TO RED ( ) SPEAKER TERMINAL.

¡ Subwoofer-Level Control	∞ Phase Switch	ª Speaker-Level Inputs
™ High-Cut (Low-Pass) Filter Switch	§ Line-Level Subwoofer (SUB) Input	‚ Master Power Switch
£ External Trigger Input	¶ Line-Level Full-Range Inputs	⁄ AC Power Cord
¢ Audio-Sense On/Off Switch	• Speaker-Level Outputs

¡Subwoofer-Level Control: Volume may be adjusted using the Subwoofer- Level Control. Turn the control clockwise to increase the SUB-TS11’s volume, or counterclockwise to decrease it.

™High-Cut (Low-Pass) Filter Switch: Placing this switch in the ON position acti- vates circuitry that cuts out all audio input signals above 120Hz, allowing the SUB-TS11 to focus its power on reproducing the low- frequency portion of the signal, avoiding inef-

ficiency and distortion. Engage this filter when using the Speaker-Level Inputs ª, or when using the Line-Level Full-Range Inputs ¶, unless your receiver or processor processes its line-level output using a low- pass filter. The filter has no effect when the SUB Input § is used.

£External Trigger Input: Use the sup- plied mini-plug cable to connect the trigger output of another product to this jack. When a trigger signal between 3 and 30 volts (AC

or DC) is detected, the SUB-TS11 amplifier will turn on, even when the Audio-Sense feature has been activated by placing the Audio-Sense On/Off Switch ¢ in the AUTO position. The amplifier will remain on for about 10 –15 minutes without an audio signal.

¢Audio-Sense On/Off Switch: When placed in the AUTO position, and when the Master Power Switch ‚ is turned on, the SUB-TS11 will automatically turn itself on or

SUB-TS11 SUBWOOFER AMPLIFIER PANEL CONTROLS AND CONNECTIONS 5