SUB-TS8 SUBWOOFER AMPLIFIER PANEL CONTROLS AND CONNECTIONS
SUBWOOFER
LEVEL
FILTER
ON ![](/images/new-backgrounds/1029696/296969xi2.webp)
![](/images/new-backgrounds/1029696/296969xi3.webp)
MIN MAX
OFF ![](/images/new-backgrounds/1029696/296969xi4.webp)
![](/images/new-backgrounds/1029696/296969xi5.webp)
ON ![](/images/new-backgrounds/1029696/296969xi6.webp)
![](/images/new-backgrounds/1029696/296969xi7.webp)
AUTO ![](/images/new-backgrounds/1029696/296969xi8.webp)
![](/images/new-backgrounds/1029696/296969xi9.webp)
PHASE
REVERSE ![](/images/new-backgrounds/1029696/296969xi10.webp)
![](/images/new-backgrounds/1029696/296969xi11.webp)
NORMAL ![](/images/new-backgrounds/1029696/296969xi12.webp)
![](/images/new-backgrounds/1029696/296969xi13.webp)
SUB R L
LINE
LEVEL
IN
HL
I
G
H
L
E
V
E
LR
OUT IN
IMPORTANT: CONNECT STRIPED WIRE TO RED (
) SPEAKER TERMINAL.
SUB-TS8 | HKTS 8 System |
| For use with |
CAUTIO N
WARNING: FOR CONTINUED PROTECTION AGAINST RISK OF FIRE, REPLACE ONLY WITH SAME TYPE T 2.5A L/250 VOLT FUSE
AVERTISSEMENT: UTILISEZ UN FUSIBLE DE RECHANGE DE MEME TYPE T 2.5A L/250V
POWER
AC 120V~60Hz
¡Subwoofer-Level Control
™High-Cut (Low-Pass) Filter Switch £ Music-Sense On/Off Switch
¢ Phase Switch
¡Subwoofer-Level Control: Volume may be adjusted using the Subwoofer- Level Control. Turn the control clockwise to increase the SUB-TS8’s volume, or counterclockwise to decrease it.
™High-Cut (Low-Pass) Filter Switch: Placing switch in the ON position activates circuitry that cuts out all audio input signals above 120Hz. This allows the SUB-TS8 to focus its power on reproducing the low- frequency portion of the signal, avoiding
∞Line-Level Subwoofer (SUB) Input § Line-Level Full-Range Inputs ¶ Speaker-Level Outputs
• Speaker-Level Inputs
inefficiency and distortion. Engage this filter when using the Speaker-Level Inputs •, or when using the Line-Level Full-Range Inputs §, unless your receiver or processor processes its line-level output using a low- pass filter. The filter has no effect when the SUB Input ∞ is used.
£Music-Sense On/Off Switch: When placed in the AUTO position, and when the Master Power Switch ª is turned on, the SUB-TS8 will automatically turn itself on or
ªMaster Power Switch ‚ AC Power Cord
place itself in the Standby mode, depending on whether it is receiving an audio signal. When this switch is placed in the ON position, the SUB-TS8 will remain on, whether or not it is receiving an audio signal.
An LED located on top of the SUB-TS8 indi- cates whether the SUB-TS8 is in the ON or STANDBY state when used with the Music- Sense On/Off Switch £ in the AUTO position. The LED is lit blue to indicate that the SUB-TS8 is receiving an audio signal
SUB-TS8 SUBWOOFER AMPLIFIER PANEL CONTROLS AND CONNECTIONS 5