MS 150
Operation
Using the Remote Control
Aim the remote at the front of the MS 150. The remote IR sensor is located in the middle of the front panel, behind the mesh grille, about 25mm (1 in) above the CD slot. Do not block the sensor. The remote has a range of approximately 6m (20 ft), up to 30 degrees off center. If the batteries require replacement, see Step 2 of the Installation section. Use caution and dispose of batteries according to environmental requirements. Never throw the batteries into fire, and remove them from the remote if it will be unused for a long period of time.
30º |
| 30º |
STANDBY |
| ON |
SOURCE | TUNE | PLAYBACK |
SLEEP | CLOCK ADJ | ALARM ADJ |
PR– EJECT PR+
TUNE–TUNE+
MUTE
VOLUME
MS 100
Setting the Clock
While the unit is in the Standby mode, set the clock: Press the Clock Adjust Mode button on the remote, and use the / buttons to set the correct hour, minute and
Figure 1: Setting the Clock
Figure 2: Setting the Alarm
Turning On the MS 150
To turn on the MS 150, press the Power On button on the remote, or press the On/Standby button on the MS 150’s front panel. The FM Radio will begin to play.
Setting the Alarm
For automatic
Press the Alarm Adjust Mode button on the remote, and use the / buttons to set the alarm time (hour, minute and
At the set time, the MS 150 will automatically turn on and begin playing the selected source. If CD or iPod/iPhone was selected and there is no disc loaded or iPod/iPhone docked, the MS 150 will switch to the FM radio source.
Play will begin at the set volume level for 10 minutes and then shut off automatically. Press any button to place the unit in Snooze mode. The alarm will remain off for 9 minutes, then it will resume.
Press and hold the On button while the alarm is playing to turn it off and return to normal play.
Setting the Alarm Volume
The default alarm volume level is 12. To change the alarm volume level, place the MS 150 in the Standby mode. Then press the Source button. The SETTINGS menu appears in the MS 150 Message Display. Press the button to toggle between the ALARM VOLUME and EQ menu options. When ALARM VOLUME is displayed, use the / buttons to set the volume level
Setting the Equalization (EQ)
The MS 150 has two equalization modes: TABLE (the default) and WALL. Use the TABLE setting when the MS 150 is
8