Venting

Requirements for Terminating the Venting

WARNING: Venting terminals must not be recessed into a wall or siding.

NOTE: Only pellet vent pipe wall pass-throughs and fire stops should be used when venting through combustible materials.

NOTE: Always take into consideration the effect the prevailing wind direction or other wind currents will cause with flyash and /or smoke when placing the termination.

In addition, the following must be observed:

A. The clearance above grade must be a minimum of 18".1

B. The clearance to a window or door that may be opened must be a minimum of 48".1

(with outside air installed, 18”)

C. A 12" clearance to a permanently closed window is recommended to prevent condensation on the window.

D. The vertical clearance to a ventilated soffit located above the terminal within a horizontal distance of 2 feet (60 cm) from the center-line of the terminal must be a minimum of 18".

E. The clearance to an unventilated soffit must be a minimum of 12".

F. The clearance to an outside corner is 11" from center of pipe.

G. The clearance to an inside corner is 12".

H.A vent must not be installed within 3 feet (90 cm) above a meter/regulator assembly when measured from the horizontal center-line of the regulator.1

I.The clearance to service regulator vent outlet must be a minimum of 6 feet.1

J. The clearance to a non-mechanical air supply inlet to the building or the combustion air inlet to any other appliance must be a minimum of 48”.1

K. The clearance to a mechanical air supply inlet must be a minimum of 10 feet.1

(with outside air installed, 6 feet )

L. The clearance above a paved sidewalk or a paved driveway located on public property must be a minimum of 7 feet.1,2

M. The clearance under a veranda, porch, deck or balcony must be a minimum of 12 inches.1,3 (see B.)

NOTE: The clearance to vegetation and other exterior combustibles such as mulch is 36” as measured from the center of the outlet or cap. This 36” radius continues to grade or a minimum of 7 feet below the outlet.

1Certain Canadian and or Local codes or regulations may require different clearances.

2A vent shall not terminate directly above a side-walk or paved driveway which is located between two single  family dwellings and serves both dwellings.

3Only permitted if veranda, porch, deck, or balcony is fully open on a minimum of 2 sides beneath the floor.

NOTE: Where passage through a wall, or partition of combustible construction is desired, the installation shall conform to CAN/CSA-B365. (if in Canada)

V

=Vent terminal

6

Page 5 Page 7
Page 6
Image 6
Harman Stove Company P61 owner manual Venting, Addition, the following must be observed, With outside air installed
Page 5 Page 7

P61 specifications

The Harman Stove Company P61 is a notable addition to the realm of pellet stoves, featuring advanced technology and a user-centric design. This powerful heating solution is ideal for homeowners looking for both efficiency and comfort, combining functionality with an elegant aesthetic that suits various interior styles.

One of the P61's standout features is its high efficiency rating, achieving over 85% combustion efficiency. This means that it utilizes fuel effectively, maximizing heat output while minimizing waste and emissions. Each pellet produces a significant amount of heat, making the P61 an economical choice for heating larger spaces.

The P61 boasts an impressive heat output, with a maximum of 61,000 BTUs, allowing it to heat areas of up to 2,500 square feet. With adjustable settings, users can easily customize the heat level to their specific preferences and needs, ensuring optimal comfort throughout the winter months. The stove also features a large hopper capacity, typically around 55 pounds, allowing for extended burn times and reducing the frequency of refueling.

Incorporating Harman's renowned Smart Control technology, the P61 comes equipped with a user-friendly digital control board. This advanced technology enables precise temperature control and can be easily configured to set specific heating schedules. Furthermore, the stove's integrated diagnostic system allows for quick troubleshooting, ensuring a hassle-free operation.

The design of the P61 allows for versatile installation options, accommodating both direct vent and optional chimney installation, which enhances its adaptability to various home settings. Additionally, the stove's aesthetics are noteworthy. It features a sleek, modern design, with several finish options, ensuring it can seamlessly blend with any home decor.

Durability is another key characteristic of the P61. Constructed with high-quality materials such as heavy-duty steel and a robust firebox, this stove is built to withstand the rigors of daily use while providing long-lasting performance. The easy-clean vertical flue design further facilitates maintenance, ensuring that users can enjoy optimal performance without significant effort.

Overall, the Harman Stove Company P61 stands out in the pellet stove market, thanks to its combination of efficiency, advanced technology, user-friendly features, and stylish design. Whether one seeks a reliable heating source or a centerpiece for their living space, the P61 delivers on all fronts, making it a worthy investment for home heating solutions.
Top Page Image Contents