GE JTP90 installation instructions Installation, Instructions, Before You Begin, Parts Included

Installation	Built-In Wall Oven
	with Microwave
	27” (68.6 cm) model
Instructions	JKP90
	30” (76.2 cm) models
	JTP90, PT970

If you have questions, call 1.800.GE.CARES or visit our website at: ge.com

Before You Begin	• Proper installation is the responsibility
	of the installer and product failure due
Read these instructions carefully and completely.	to improper installation is NOT covered
• IMPORTANT—Save these	under warranty.
	• NOTE—This appliance must be properly
instructions for local inspector’s use.
	grounded.
• IMPORTANT—Observe all
	• ATTENTION INSTALLER
governing codes and ordinances.
• Note to Installer—Be sure to leave these	All electric wall ovens must be hard wired
instructions with the consumer.	(direct wired) into an approved junction
• Note to Consumer—Keep these	box. A plug and receptacle is NOT permitted
	on these products.
instructions for future reference.

Parts Included
(Appearance will vary.)
Screws For		27″ (68.6 cm)
		Metal Bottom Trim
Installation
(8-18 x .750
flat head Phillips
wood screws)
	Optional 27″	30″ (76.2 cm)
	(68.6 cm) Metal	Metal Bottom
	Bottom Trim	Trim Assembly
	Assembly (on
	some models or
	can be purchased
	separately)
31-10648-1	03-07 JR

Materials Needed

Wire Nuts

Strain Relief Clamp	Junction
for 1/2” conduit	Box

36” (91 cm) of String

Tools Needed

1/8” Drill Bit and	Phillips
Electric or Hand Drill	Screwdriver

1