Installation Instructions
A
Cutout for 30″ (76.2 cm)
For JTP90, PT970 models only.
Allow 11/16” (1.8 cm) for overlap of oven over side edges of cutout
Allow a minimum of 21”
(53.3 cm) for clearance to adjacent corners, drawers, walls, etc.
when door is open
21” (53.3 cm)
Cabinet
Width
30” (76.2 cm)
Cutout Width 
28 1/2”
(72.4 cm) Min.
285/8”
(72.8 cm) Max.
Opening between
inside walls must be at least 28 1/2”
(72.4 cm)
wide
20” (50.8 cm) 
Max.
Junction Box
Location
Cutout |
|
|
|
| |
Height |
|
|
|
| |
42 3/16” |
|
|
|
| |
(107.2 cm) |
|
|
|
| |
28” (71.1 cm) | Min. | ||||
Min. |
| ||||
| to Bottom of | ||||
42 1/4” |
| ||||
| Junction Box | ||||
(107.3 cm) |
| ||||
Max. |
|
|
|
| |
|
|
|
|
| |
Cabinet Width | 30” (76.2 cm) | |
Recommended |
|
|
Cutout Location |
|
|
from Floor | 21 | 5/8” (54.9 cm) |
Cutout Depth | 23 | 1/2” (59.7 cm) Min. |
Cutout Width | 28 | 1/2” (72.4 cm) Min. |
| 28 | 5/8” (72.8 cm) Max. |
Cutout Height | 42 | 3/16” (107.2 cm) Min. |
| 42 | 1/4” (107.3 cm) Max. |
NOTE: If the cabinet does
not have a front frame and the sides are less than 3/4” (1.9 cm) thick, shim both sides equally to establish the cutout width.
Allow minimum 1”
(2.5 cm) for overlap of oven top and 11⁄4”
(3.2 cm) overlap of bottom of cutout
Recommended cutout location from floor 21 5/8” (54.9 cm)
If the cabinet does not have a solid bottom, two braces or runners must be installed level with the bottom of the cutout to support the weight of the oven. The runners and braces must support
255 lbs (115 Kg).
NOTE: If marks, blemishes or the cutout opening are visible above the installed oven, it may be necessary to add wood shims under the runners and front trim until the marks or opening are covered.
Suitable
Bracing to Support Runners
C |
L |
215/8”
(54.9 cm)
Over Centerline
of Cabinet
2” x 4”
(5 cm x 10 cm) or equivalent runners level with bottom of cutout
5
