GE JKP90, JTP90 Installation Instructions, C3Preparing for the Bottom Trim Installation

Installation Instructions

C3 Preparing for the Bottom Trim Installation

a. With oven installed, take the bottom trim and center it on the bottom front edge of the cabinet opening.

b. Using the trim	For 27″ (68.6 cm)
	models with Lower
as a template,
	Trim in Position,
mark the center	Mark (2) Mounting
of each slot	Hole Locations here
(two total) where
the mounting holes
will be drilled.			*
c. Remove the trim.
		* Remove	For 30″ (76.2 cm)
			models with
d. Drill pilot holes into		Lower Trim
			Lower Trim in
		Before
the center of each			Position, Mark (2)
		Pre-drilling
			Mounting Hole
template mark.		Mounting
			Locations here
		Holes

C4 Installing the Metal

Bottom Trim

a. Place the bottom metal trim centered over the pre-drilled mounting holes. Tape the edges of the trim down to maintain the alignment.

b. Using two trim screws provided, secure the bottom trim to the bottom edge of the cabinet.

Trim Screw
Locations for	Side
27″ (68.6 cm)	Trim
models with
Lower Trim
Side
Trim

Metal Lower Trim

Trim Screw Locations for 30″ (76.2 cm) models with Lower Trim

IMPORTANT: If this unit is ever removed from the cabinet or the oven is ever pulled out for service, the trim must be removed first or damage to the trim will occur.

10