TROUBLESHOOTING:
PROBLEM: The lift will not operate or operates slowly.
Possible Causes:
Bad
PROBLEM: Intermittent power to the lift. The lift will operate for a short period of time and quit. At a later time it will start working again.
Possible Causes:
Circuit
Bad
Hand
PROBLEM: Lifting arm is slow to swing in / out. (AL400 only)
Possible Causes:
Dirty
Bad
PROBLEM: The lifting strap operates in reverse.
Possible Causes:
The lifting strap was overextended. The lifting strap was lowered too far, causing the strap to wind around the spool backwards. Lower the strap until it unravels from the spool. Then, raise the strap in the proper direction.
PROBLEM: AL400 rotates in wrong direction when installed on the passenger side of the vehicle.
Possible Causes:
The lift is shipped from the factory to be mounted on the drivers side of the vehicle. To change the rotation for the passenger side remove the bolt located near the bottom of the post, rotate the motor 180 degrees and reinsert the bolt. Next, change the rotation of the motor located in the base by switching the wires on the motor to reverse the polarity.
PROBLEM: The scooter or chair tips to the front or back while it is being lifted.
Possible Causes:
The scooter or chair is being lifted off center. The docking device should center the lifting strap over the center of gravity which is generally around the center of the seat. Check to make sure the proper docking device is being used.
10