Havis-Shields KK-K9-D22-K Remove necessary interior trim parts, Place Floor

Rear of vehicle

Always!

Read all instructions before installing any Havis-Shields Equipment Corp products. Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes! Use hardware provided with install kit

TIPS FOR INSTALLATION:

•Cordless drill with Phillips screw bit is recommended to help speed up installation time.

•Rear and ceiling fillers as well as step sill may require you to apply pressure when attaching them to the cage. This will aid in achieving a clean tight fit and may require two installers during these steps.

•PVC protective covering should be removed during installation. Peeling it back while attaching hardware.

Remove OEM

door rod

SUB ASSEMBLIES:

1.Remove necessary interior trim parts:

•Remove rear seat

•Remove OEM door panels.

Note: if the door has an electric lock system and/or window controls, the switches must be reconnected. The switch assembly must be wire tied to inner door panel and placed inside a plastic bag so, as not to interfere with the window or lock mechanisms.

• Remove OEM door lock pin assembly

• Remove OEM step sill panel

• Remove seat belts – remove inboard belt latch and buckle (center of car)

2. Loosely attach rear-mounting foot to vehicle using factory seat hardware on floor of vehicle.

Note: DO NOT tighten these bolts until Step 6 of the installation process.

INSTALLATION:

1. Place Floor:

KK-K9-D22-K_INST_9-07