
Dome Light KR-DL
Installation Instructions
Warning: Please read all instructions and warnings prior to installation of the Dome Light.
TOOLS REQUIRED: |
|
| |
Phillips Screw Driver | Wire Cutter | ||
HARDWARE: (Supplied in Kit) |
|
| |
Qty. | Description | Qty. | Description |
2 | 2 | #8 Fender Washer | |
2 | #8 KEP Nut | 2 | #8 Sheet Metal Screw |
INSTALLATION:
1.Mounting:
•A drill template is provided on the back of this instruction sheet. Detach the template, position it on the desired location for installation, and mark drill locations.
Caution: Before drilling holes, ensure that the mounting surfaces are clear and that the screws will not damage the internal parts of the vehicle.
Caution: Ensure that the Dome Light is installed in areas recommended by the vehicle manufacturer.
•Drill the mounting holes.
•Connect the power leads using wire splices.
•Remove the template prior to installing the fixture. Secure the base of the fixture in position using the supplied machine screws, washers, and nuts.
Caution: Thread forming screws are supplied for alternate installations. If the fixture needs to be mounted with thread forming screws, please note that it may not always be sufficiently secured. It is at the sole discretion of the installer to determine the suitability of using thread- forming screws for a particular installation.
•The fixture is supplied with two clear lenses and two red lenses. Install two lenses suitable for the vehicle.
•Test the fixture for proper operation.