OPERATING THE MOWER
Adjusting the Cutting Height
2
305113
1 = HIGH
2 = MID
3 = LOW
2
1
3
The cutting height of your mower has been set at the highest position (1). If you prefer a lower cut follow these instructions:
a.Turn the petrol tap to the off position and where fitted the vent screw.
b.Disconnect the spark plug lead.
c.Tilt the mower to its side. (Keeping the carburet
d.Remove flexiblade from cutting disc.
e.There are 3 different cutting height settings. Position one length of flexiblade into the desired cutting height setting. Ensure that a second length is positioned in the corresponding cutting height on the opposite side of the cutting disc.
If using spare reel of flexiblade, cut to the length of 200mm and fit as above.
Flexiblade Replacement
Drain the fuel by running the engine until the fuel tank is empty and the engine stops. Remove the spark plug lead and allow the engine to cool. Turn the mower on its left hand side and ensure that the carburet- tor is uppermost.
Wearing protective gloves remove flexiblade and replace with new.
Before Mowing
To prevent accidents, thoroughly inspect the area and remove all objects which when contacted by the mower cutterbar could become dangerous projectiles. Inspect the area for hidden obstructions which when contacted by the cutterbar could risk health and safety or result in damage to the mower. Remember the location of these obstructions and ensure that you mow around them.
1.16
