Figure 23

4.Slowly pour oil into the oil fill tube until the oil level reaches the Full line on the dipstick (Figure 6). Do not overfill. (Max. fill: 0.59 l, type: SAE 30W detergent oil with an API service classification of SF, SG, SH, SJ, SL, or higher.)

5.Install the dipstick securely.

6.Dispose of the used oil properly at a local recycling center.

Electrical System

Maintenance

Charging the Battery (Model 447F Only)

Service Interval: Every 25 hours—Charge the battery for 24 hours. (Model 447F only)

Always use the charger in a sheltered area and charge the battery at room temperature (22° C) whenever possible.

1.Connect the charger to the mower wire harness located below the ignition key (Figure 24).

Figure 24

2.Plug the charger into a wall outlet.

Note: When the battery no longer holds a charge dispose of the lead-acid battery.

Replacing the Fuse (Model 447F Only)

If the battery does not charge or the engine does not run with the electric starter, the fuse may be blown. Replace it with a 40-amp plug-in type fuse. Refer to Installing the Fuse.

15

Page 15
Image 15
Hayter Mowers manual Electrical System Maintenance, Replacing the Fuse Model 447F Only