ASSEMBLY

Place all parts of the AEROFLYER in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Read through all assembly steps before you begin.

Assembly requires a phillips screwdriver (not included).

1.Refer to figure 1a. Stand at the front of the AEROFLYER, hold the Frame (1) in the indicated locations, and raise the AEROFLYER to the position shown. Refer to figure 1b. Put your foot on the round tube. Using your foot, pull the round tube toward yourself until the Uprights (5, 6) are fully extended. Before you proceed with assembly, make sure that the Uprights are fully extended and are resting against the stops (see figure 1a).

2.Slide a Lock Washer (16) onto the Lock Knob (32). Insert the Lock Knob into the hole near the top of the Left Leg (2). Tighten the Lock Knob into the Link Plate (7).

3.The Electronic Monitor (9) requires two ÒAAÓ batteries (not included). Alkaline batteries are recommended. Press the tab on the battery cover and remove the battery cover from the Monitor. Insert two batteries into the Monitor. Make sure that the negative (Ð) ends of the batteries are touching the springs in the Monitor. Close the battery cover.

Fig. 1a

Hold

Fig. 1b

 

 

 

 

 

Here

 

 

 

 

 

1

5

Stop

 

Foot

 

 

 

6

1

5

 

 

 

 

Back

Front

Round

6

 

 

 

 

Tube

 

Fig. 2

 

 

 

 

16

32

 

7

2

 

 

Fig. 3

 

 

 

 

 

9

 

 

 

 

Batteries

 

 

 

Battery

 

 

Tab

Cover

4

Page 4
Image 4
Healthrider HRAW75070 manual Assembly requires a phillips screwdriver not included, Back Front