ASSEMBLY
Assembling the handlebar and throttle
•Unscrew the knob from the handlebar mounting.
•Position the handlebar as shown. Fit the mounting components and tighten the knob lightly.
•Fit the right handle to the handlebar using the screw, washer, sleeve and nut as shown. Tighten.
•Put on the harness and hang the machine from the support hook. Now make a final adjustment so that the machine is in a comfortable working position when it hangs from the harness.
Tighten the knob.
Transport position, handlebar
•The handlebar can easily be turned to fit along the shaft for easier transportation and storage.
•Loosen the knob. Turn the handlebar clockwise so that the throttle handle rests against the engine.
•Now twist the handlebar around the shaft. Tighten the knob.
•Fit the transport guard to the cutting attachment.
Fitting blades and trimmer heads
When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury.
WARNING! Never use a cutting attachment
!without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury.
IMPORTANT! If a saw blade or grass blade are to be used the machine must be equipped with the correct handlebar, blade guard and harness.
English – 17
