Healthrider HREL05983 manual

6.Slide an M8 Split Washer (58) and an M8 Washer (81) onto an Axle Screw (30). Tighten the Axle Screw into one end of the Incline Axle (29). Next, apply a small amount of the included grease to the Incline Axle. Align the indicated tubes on the Incline Frame (5) with the tubes on the Base (1). Make sure that the Incline

Frame is turned so the V-shaped grooves are on top. Insert the Incline Axle (29) through the Incline Frame and the Base. Note: It may be helpful to tap the Incline Axle with a rubber mallet to insert it.

Slide an M8 Split Washer (58) and an M8 Washer (81) onto the other Axle Screw (30). Tighten the Axle Screw into the open end of the Incline Axle (29).

7.The Console (87) requires two “AA” batteries (not included). Alkaline batteries are recommended. To install batteries, turn the console over and insert two batteries into the battery clip as shown in the inset drawing. Make sure that the negative ends of the batteries (marked “—”) are touching the springs in the battery clip.

Attach a Plastic Tie (53) to the battery clip as shown. Attach the Console (87) to the Console Base (49) with four M4 x 16mm Screws (35), making sure that the indicated wires are extending from the Console Base (49). Be careful not to pinch the wires.

8.Connect the Extension Wire (51) to the corresponding wire on the Console (87).

Next, connect the two Pulse Wires (86) to the two remaining wires on the Console (87). Note: Either Pulse Wire can be attached to either wire on the Console.

Next, connect the ground wire to the indicated hole in the Upright (2) with an M4 x 16mm Screw (35). Carefully feed the wires down into the Upright (2). Attach the Console Base (49) to the Upright with four M4 x 16mm Screws (35). Be careful to avoid pinch- ing the wires.

7

6			V-shaped Groove
			5	58
	1		81
				30
Grease
			Tubes
58	81	29	Tubes
30
7	87		Batteries
				53
49			Battery
			Clip
	Wires		35
8
			87
	Console
	Wires		49
	86	51	35
			Ground Wire
			35
35		2