Crossbar Screws yet | Healthrider HRTL34305.0

3.With the help of a second person, position the treadmill with the Uprights (62, 76) in the vertical position as shown.

Route the Wire Harness (21) through the bracket on the Right Handrail (47) and out the large hole on the side of the Right Handrail. Insert the bracket on the Right Handrail into the top of the Right Upright (62). Attach the Right Handrail with two 1” Bolts (8) and two 1/4” Star Washers (9) as shown. Do not tighten the Bolts yet.

Attach the Left Handrail (not shown) as described above. Note: There is not a wire harness on the left side.

4.Hold the Crossbar (34) between the Handrails (1, 47). Attach the Crossbar with two Crossbar Screws (53) and two Crossbar Star Washers (88). Do not tighten the

Crossbar Screws yet.

Hold the Console (10) and the Console Base (46) near the Handrails (1, 47). See the inset drawing. Route the ground wire (A) from the Console Base through the open- ing at the side of the Console Cover (96). Next, route the ground Wire through the two indicated plastic ties on the Console Base.

Attach the end of the ground wire (A) to the small hole in the side of the Right Handrail (47) with a Silver Ground Screw (91).

5.Place the Console Base (46) on the Right Handrail (47) and the Left Handrail (not shown). Attach the Console Base with four 3/4” Screws (13) (only two Screws are shown). Do not tighten the Screws yet.

Insert the Wire Harness (21) through the two indicated plastic ties on the Console Base (46). Next, insert the Wire Harness up through the indicated opening in the Console Base. Make sure that the Console Cover (96) is securely attached to the Console Base.

See the inset drawing. Look at the top of the Console Base (46). Insert the Wire Harness (21) through the plas- tic tie on top of the Console Base.