![](/images/new-backgrounds/1010488/1048835x1.webp)
5700 ACT Wood Stove
R
OUTSIDE AIR KIT INSTALLATION
Included in Kit: 1 front cover; fiberglass rope; 2 vent straps; venting flange & 4 screws; termination cap
&screws. Not all materials are needed for each model.
Items Needed for Installation: 4” (102mm) flex pipe in the length as required for your installation; Phillips screwdriver; Silicone sealant; Drills and saws necessary for cutting holes through the wall or flooring in your home.
1.Remove all materials from packing box.
2.Using a #2 Phillips screwdriver, remove 2 bolts beneath the ashcatcher.
3.Install side covers to each side. Slide covers into area and secure with 4 sheet metal screws.
4.Floor installation: Cut a 4” (102mm) minimum hole in the floor to accommodate outside air piping. Use 4” (102mm) metal flex or rigid piping to directly connect outside air to the unit or into vented crawl space. (Do not put flex into a
5.Rear/wall installation: Cut a 4” (102mm) hole in outside wall to accommodate outside air piping. Use 4” (102mm) metal flex or rigid piping to directly connect outside air to stove intake. Use the supplied termination cap with a rodent screen. Seal between the wall and the pipe with silicone to prevent moisture penetration. Install fiberglass sealing rope under each side of pedestal.
Pedestal Model
| Flex |
| Flange |
Front | |
Cover | view |
| |
| 4 in. (102mm) Flex |
Fiberglass | Line (Not Included) |
Sealing | Side |
rope | Cover |
(2)Outside Air Termination Cap (Contains rodent Screen)
FIGURE 18A
Leg Model
| 4 in. Flex Line |
| (Not Included) |
Front |
|
Cover |
|
| Flex Flange |
Side Cover | Outside Air Termination Cap |
(2) | (contains rodent screen) |
|
FIGURE 18B
Page 18 | September 1, 2008 |