R

BODEGA BAY WOOD INSERT

BLOWER CORD LOCATION & BLOWER

CONTROL BOX WITH SWITCH

This insert comes standard with a blower, installed at the factory with blower cord on right side of insert (as you face the unit). The blower cord can also be installed on the left side. Disconnect the cord from right side. ROUTE WIRES IN FRONT OF FAN. Re-install on the left side. Do not route cord behind the cooling fan.

Figure 14A

FAN (BLOWER) REPLACEMENT

Included in Kit: Replacement Blower

Tools Needed: 5-32 Wrench and Phillips Head Screwdriver.

1.Remove bolts from both sides of the insert and slide the lower cover towards you. See Figure 14D

2.Remove 6 that secures motor to the housing. Remove the motor. See Figure 14E.

3.Attach new motor using the same screws to the blower housing.

4.Re-attach lower cover to insert using the bolts removed in Step 1.

Black

Red

Snap Disc

White

 

Black

Blower Control

 

Box with Switch

Cooling Fan

Figure 14B - Right Side Location

Black

Red

Snap Disc

White

 

Cooling Fan

Figure 14C - Left Side Location

Remove Bolt

Remove Bolt

Figure 14D

Figure 14E

Operating the Blower Control Box with Switch

1.The blower will turn on/off automatically when set to AUTO.

2.When set to MANUAL, the fan will turn on/off only when you turn it on or off. This setting over-rides the internal snap disc.

AUTO: Fan will

MANUAL

 

turn ON/OFF

FAN

automatically and

AUTO

is controlled by the

 

internal Snap Disc

LOW

 

MANUAL: Over-rides the internal Snap Disc

3.Adjust the speed of the fan by turning the HIGH/LOW knob to the desired setting.

HIGH OFF

Figure 14C

Page 14

435-1320B

August 20, 2008

Page 14
Image 14
Hearth and Home Technologies BODBAY installation instructions Blower Cord Location & Blower Control BOX with Switch