Hearth & Home Technologies Inc.
1445 North Hwy., Colville, WA
2.Cleaning the Back Glass
The glass is cleaned in the factory during the assembly process. During shipment, installation, handling, etc., the glass surface may collect dust particles. These can be removed by buffing lightly with a clean dry cloth.
To remove fingerprints or other marks, the glass can be cleaned with a damp cloth using a good quality household glass cleaner. The glass should be completely dried with a lint free cloth or paper towel.
In the event of glass breakage, vacuum all remaining glass pieces with a shop vac. DO NOT VACUUM IF PIECES ARE HOT! Replace glass with only a glass panel ordered direct or through your local distributor. Never use substitute material. Only fully tempered soda lime safety glass may be used on this heater.
3.Replacing the Light Bulb
The light bulb will need to be replaced when the flame and/or ember bed is dark. Replace the bulb with a 75 watt halogen bulb with
a.Turn off the circuit breaker or unplug the stove before replacing the light bulb.
b.Light bulb access is on the bottom of the stove.
c.Locate and remove the screw. See Figures
d.Lower the cover plate to access the light bulb.
e.Carefully remove the burned out bulb from the light socket. Place the new bulb in the socket. Follow directions on the light bulb package for handling requirements.
f.Reinstall the cover plate. Make sure all wires are back inside the stove.
g.Reinstall the screw removed earlier.
h.Plug the stove’s power cord into the electrical outlet and turn the switch to “ON”.
Safety Note:
Handle glass with care to avoid striking, scratching or slamming shut. NEVER clean glass when it is hot. Keep children and pets a safe distance away.
WARNING!
To avoid accidental burning of the skin, allow at least 5 minutes for the light bulb to cool before touching it.
Figure 6 - Removing Screw | Figure 7 - Replacing the Bulb |
8 | GarnetE SERIES ELECTRIC FIREPLACE |
5/04
