1
Note:
shipping damage, inform your dealer immediately!
Caution when unpacking:
Lift the range by the bottom skirt, do not lift by nickel trim.
Unpacking:
Note: to avoid injury, please wear safety equipement, glasses and gloves, while you are unpacking your new range.
1) Unscrew the 12 screws that hold the crate onto the skid. There are 12 along the bottom and 4 along the top.
2) After the screws have been removed, carefully lift the crate over the stove and set it aside.
3) Next with a pair of tin sips cut the metal banding that holds the stove into place.Caution metal banding is under
tension!
4) Carefully remove the metal banding, the 2 boards that where under the banding and the cardbord cap and
styrofoam.
5) You are now ready to remove the range from the skid.
For 30" units have one person at each end stand beside the skid and carefully lift the range by the bottom skirt, and a
not your back!
For 48" units units have one person at each end and one side, stand beside the skid and carefully lift the range by the
bending your knee's not your back!
6) Finish unpacking the range removing packing tape around the doors and in the oven.
Both 30" and 48" Ranges consist of two main parts: The Range Body, and
The Cabinet / Exhaust Hood
Tools required for assembly: - Phillips/Robertson Screwdriver
- 5/16" ( 8 mm) wrench or crescent wrench
Assembly and Installation
To fully enjoy your new range, it is important that you read this booklet thoroughly.
1/8"- 1/4"
Figure 1
observed except when range is equipped with a cord and plug
approximately 1/8"-1/4". Adjusting levelling bolts in too far will
Gliders: