B. Lighting the Appliance
Electronic Ignition
FOR YOUR SAFETY 
READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
LIGHTING 
INSTRUCTIONS
1. This heater is equipped with an igni- |
tion device which automatically lights |
the burner. Do not try to light the |
A. This heater is equipped with an electronic pilot ignition device which automatically lights the burner. Do not try to light the burner by hand.
B. BEFORE LIGHTING, smell all
around the heater area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas sup- plier, call the fire department.
C. Do not use this fireplace if any part has been under water. Immediately call a qualified service technician to inspect the heater and to replace any part of the control system and any gas control which has been under water.
burner by hand. |
2. Wait five (5) minutes to clear out any |
gas. Then smell for gas, including |
near the floor. If you smell gas, STOP! |
Follow “B” in the Safety Information |
located on the left side of this page. If |
you don’t smell gas, go to next step. |
WARNING: 
CAUTION:
3. To light the burner, simultaneously | ||
press the star | and up | arrow |
Improper installation, adjustment, alteration, service or maintenance can cause injury or property dam- age. Refer to the owner’s information manual provided with this fireplace.
This heater needs fresh air for safe operation and must be installed so there are provisions for adequate combustion and ventilation air.
If not installed, operated, and main- tained in accordance with the man- ufacturer’s instructions, this product could expose you to substances in fuel or fuel combustion.
Keep burner and control compart- ment clean. See installation and operating instructions accompany- ing heater.
Hot while in operation. Do not touch. Keep children, clothing, furniture, gasoline and other liquids having flammable vapors away.
Do not operate the heater with panel(s) removed, cracked or bro- ken. Replacement of the panel(s) should be done by a licensed or qualified service person.
NOT FOR USE
WITH SOLID FUEL
For use with natural or propane gases.
buttons on the remote control until a |
short acoustic signal confirms the start |
sequence has begun. |
4. If the heater will not operate, check the |
batteries then follow the instructions |
“To Turn Off Gas to Heater” and call |
your service technician or gas sup- |
plier. |
TO TURN OFF GAS TO HEATER
1.Push the ‘OFF’ button on remote.
2.Remove batteries from receiver.
28 | Heat & Glo • |
