Heat Controller, Inc. | INSTALLATION INSTRUCTIONS | SMA/SMH 09/12 |
Installation Parts
Please install the accessories attached with unit correctly according to this installation manual.
Part No. | Name of Part |
| Quantity | |
1 | Installation Plate |
| 1 | |
2 | Mounting Screw A | 8 | ||
3 | Anchor |
| 8 | |
|
| Liquid side | o 1/4" |
|
|
|
|
|
|
4 | Refrigerant Pipe | Gas Side | o 3/8" (<12,000 Btu/h) |
|
|
| o 1/2" (≥12,000 Btu/h) |
| |
|
|
|
| |
|
|
|
|
|
5 | Remote Controller |
| 1 | |
6 | Seal* |
| 1 | |
7 | Drain Elbow* |
| 1 | |
* See outdoor installation instructions
**Cautions on remote controller installation
•Keep the remote controller at least 3 feet from the nearest TV set or stereo equipment to advoid possible electronic interference.
•Do not leave the remote controller in a place exposed to direct sunlight or close to a heating source, such as a stove.
•Ensure that the positive and negative poles are correct when inserting batteries into the remote controller.
Anchoring the Outdoor Unit
•The outdoor unit should not be exposed to strong winds
•Anchor the outdoor unit with o1/4" or 5/16" anchor bolts
12000Btu/h | " | " |
12000Btu/h | " | " |
Note:
1.Be sure sides A, B, and C are free from block- age/obstacles to allow sufficient clearance for air flow and maintenance.
2.When the outdoor unit is higher than the indoor unit, to prevent rain from flowing inside, make a
3.The illustrations are only sketches. Actual units may be slightly different.
6 Seal | 7 | Drain |
| Elbow |
**
UBend example
2
