Two-Note, Single
Entrance Chime
Model 23/M | Battery or Transformer Operated |
|
This package includes (Style of chime may vary from illustration):
•Chime
•Mounting Screws
•Instructions
New installations require:
•Push Button
•4 - “C” Batteries or 1 - 8/10V Transformer
•#20 AWG Bell Wire (such as Heath®/Zenith 196C or 199C)
Chime
Cover
2 
1
3 
Base
Plate
Figure 1
To Push Button
1 
2
3 
Figure 2 - Battery Operation
MOUNTING THE CHIME
Position chime at eye level in desired room. Sound travels farthest with the fewest obstacles. Do not place over heat source; i.e., radiator, heater, or stove.
At the chosen location drill two small pilot holes
3 1/4" apart in the vertical plane. The chime cover |
is a push fit onto the base. Remove chime cover |
to expose base. Position base and mount in place |
using screws supplied, |
top (see Figure 1). |
WIRING THE CHIME |
A. Battery Operation. Do not use with lighted push |
button. Fit (4) “C” batteries noting + or - marked on |
the base plate. Alkaline batteries offer longer life. |
Batteries are not included. |
To connect bell wire from chime to push button, cut |
it to required length, strip back outer coating 1/2", |
wrap exposed wire around chime terminals #1 and |
#2 only and tighten screws. NOTE: No connection |
to chime terminal #3 (see Figure 2). |
B. For Transformer Operation Only. |
1 
2
3 
To Push Button
To 8/10V Transformer
WARNING: Turn off housepower before start- |
ing installation. Failure to do so may result in |
danger from electric shock. |
Connect chime terminals #1 and #3 to the low |
voltage terminals of an 8V or 10V transformer |
(Heath®/Zenith 107C or 125C) using #20AWG bell |
wire (see Figure 3). |
Figure 3 - Transformer
Operation
© 2007 HeathCo LLC |
