3.Walk through the coverage area noting where you are when the lights turn on.In TEST mode, light will stay on for 5 seconds after sensing motion and then turn off.
4.Move the sensor head left or right to change the coverage area. Note: Grasp the sensor only as shown and turn the entire sensor.Anyother method may damage the sensor. Do not force it past the stops.
The sensor is less sensitive to motion directly towards it and more sensitive to motion across coverage area.
MotionMotion
| Sensor |
Least Sensitive | Most Sensitive |
Sensor
Aiming 
240°
Adjustment
Angle
5.Adjust the SENSITIVITY to increase or decrease the range as needed. Too much sen- sitivity may cause false triggering due to heat sources in the coverage area (see Adjustment of Coverage Area or Troubleshooting section).
6.Set the amount of
| 150° |
6 ft. |
|
(1.8 m) |
|
30 ft. |
|
(9.1 m) |
|
Maximum Range | Maximum |
Coverage Angle*
(Top View)
OPERATION
Mode: | Works: Day | Night | |
Test | 5 Seconds | x | x |
Auto | 1, 5, or 10 |
| x |
| Minutes |
|
|
Manual | To Dawn* |
| x |
* resets to Auto Mode at dawn.
Note:When first turned on wait about 1 1/2 minutes for the circuitry to calibrate.
MANUAL MODE
Manual mode only works at night because daylight returns the sensor to AUTO.
Flip the light switch off for one | 1 Second |
second then back on to toggle | OFF then... |
between AUTO and MANUAL |
|
MODE. |
|
Manual mode works only with |
|
the |
|
5, or 10 position. | ... back on. |
