Heath Zenith 5326 manual DualBrite Motion Sensor Light Control, Operation, Model, Features, Test

DualBrite® Motion Sensor Light Control

Model 5326

Features

•Turns on lighting when motion is detected.

•Automatically turns lighting off.

•Softstart lighting technology slowly increases light intensity when lights turn on and slowly decreases light intensity when lights turn off.

•DualBrite® Timer.

•Photocell keeps the lighting off during daylight hours.

•LED indicates motion was sensed (day or night).

This package includes:

Bulb
Holders		Rubber Plug
		Plastic Hanger
Cover
Plate	Sensor
Light Control		2 Wire
		Connectors
Mounting Bolt	Mounting Strap

Requirements

•The light control requires 120-volts AC.

•If you want to use Manual Mode, the control must be wired through a switch.

•Some codes require installation by a qualified electrician.

•This product is intended for use with the enclosed gasket and with a junction box marked for use in wet locations.

OPERATION

Mode:	On-Time	Works: Day	Night
Test	5 Seconds	x	x
Auto	1, 5, or 20 Min		x
Manual	To Dawn*		x
Accent	3, 6 Hr, to Dawn		x

* resets to Auto Mode at dawn.

Note: When first turned on wait about 1 1/2 minutes for the circuitry to calibrate.

TEST

Put ON-TIME switch	ON-TIME	DualBrite®
on the sensor bottom
to TEST and the Dual-
	TEST 1 5 20	Off 3 6 Dusk to
Brite® switch OFF.			Dawn

AUTO

Put the ON-TIME switch in the 1, 5,	ON-TIME
or 20 minute position.
	TEST 1 5 20
MANUAL MODE

	Gasket
	6 Screws
2 Shells	(3 sizes included)

Manual mode only works at night because daylight returns the sensor to AUTO.

Flip the light switch off for one second then back on to toggle between AUTO and MANUAL MODE.

Manual mode works only with the ON-TIME switch in the 1, 5, or 20 position.

1 Second OFF

then...

... back on.

© 2008 HeathCo LLC 598-1269-02