-2- 598-1172-04
TR-0035-RX
TR-0095-RX
TYPE
C
5. Adjust volume control. Adjust volume control to desired volume
(seeFigure3).
6. Mount push button.Use eitherscrews ordouble sidedtape to
mountpushbutton.
• ScrewMounting:Tomountwithscrews, removebackofcase
bypushingintabonbottomwithasmallscrewdriver(seeFigure
1).Attachbackofcasetodoorjamborwall(seeFigure5).Snap
frontofpushbuttonon.
• Tape Mounting:Whenattachingpushbuttonusingdoublesided
tape,makesurethesurfaceofthedoorjamborwallisclean.
7. Determine cover mounting type.Thecoversuppliedwiththechimebasewilleithersnap
ontothebaseorhangfromacoverpin.
• Snap-On Cover:Applypressuretothecoveruntilitsnapsintoplace(seeFigure6).To
remove,rmlygraspcoverandpull.
• Hanging Cover:Beforemountingchimebasetowall,slidethecoverpinthatwillbeon
topofthemountedbaseoutofthebase.Turnitoversothepinisprotrudingabovethe
base.Slidethecoverpinintobase(seeFigure7).Hangcoveroncoverpin.
Note:Coverpinsarelocatedontwosidesofthechimebaseforusewithhangingcovers.When
chime base is mounted according to mounting orientation marking, use the cover pin located
onthetopofthechimebaseforhangingthecover.
Cover Pin
Chime Base
Figure 6
Snap-On Cover
Mounted
Chime Base
Figure 7
Figure 5