-5-
598-1172-04
TROUblESHOOTING
A. Chime does not sound:
• Makesurepushbuttonandchimecodesarethesame(seeFigure10).
• Checkorientationofpushbuttonandchimebatteries.(Seediagraminsidepushbutton
andchimeforcorrectbatteryorientation.)
• Checkchargeofpushbuttonandchimebatteries,replaceifnecessary.
B. Chimesoundswhennotintended(falsetriggers):Chime is receiving interference from
anotherwirelessdevice;changethecodesetting(seeCode Settingbelow).
C. BatteriesseemOK,butthechimedoesnotworkwheninstalled:
• Donotmount chimeorpushbutton onmetalornearmetal studs.Thisreducesthe
transmitterrange.Use1/4"to 1/2"(6to13 mm)woodshimsto movechimeorpush
buttonoffmetalsurface.
• Concreteoorsmayreducerange.Movechimeawayfromoor.
• Trylocatingchimeclosertopushbutton.
D. Code Setting:
It is recommended to only change one code position at a time and then check to see if system
isfunctioningproperly.
1. Openthecasesandlocatethe jumpersonboththepush buttonandchime(seeFigure
10).
2. Thepushbuttonandchimebothhaveeightdifferentjumperlocations.Jumperpositions1
through7areusedforsettingthecode.
Continued