WARNING: Turn power off at the circuit breaker before wiring.
Installing Sensor
Removing Control Panel Cover
1.Remove the decorative cover plate (secured by two small screws).
ON
OFF | AUTO |
|
Typical Installation
1.Remove existing wall switch from junction box.
2.Connect electrical leads of sensor as shown in Figure 3. Before installing sensor into junction box, make sure there is no wire exposed at each connection.
3.Mount sensor into junction box using two large mounting screws provided.
4.Turn the power back on at the circuit breaker.
5.Set mode selection switch to the AUTO posi- tion. When unit stabilizes (about 1 minute), the sensor is ready to detect motion. If sensor detects motion, the lights will turn on. The lights will turn off 5 minutes after motion is no longer detected.
Figure 2 - Removing Control Panel Cover
To Lighting Load
Mode
Selection
Switch
Black
OFF AUTO ON
Black
Neutral
Return
Lighting Load
Green ground wire to junction box screw or grounding wire.
Line “Hot”
Figure 3 - Connecting Electrical Leads of Sensor