Wireless Chime
Models 6153 / 62 / 71 / 72
This package includes (Style of push button and chime may vary from illustration):
•Wireless chime
•Wireless push button (model 6162 includes 2) with battery
•Hardware pack
This chime requires 3 “D” alkaline batteries (not included). In typical use,
alkaline batteries will last up to three years.
Figure 1
Figure 2
Chime
Volume
Type “D” | Type “D” | Type “D” |
Figure 3
WARNING: To prevent possible SERIOUS INJURY or DEATH:
•NEVER allow small children near batteries.
•If battery is swallowed, immediately notify doctor.
1.Install alkaline type A23 12 volt push button battery (included). Remove back of case by pushing in tab on bottom with a small screw- driver (see Figure 1). See diagram inside push button for correct battery orientation. Note: If batteries are preinstalled, remove orange battery tab.
2.Open chime case. Press in catch on bottom of chime and lift the case open (see Figure 2).
3.Install 3 alkaline “D” batteries. Make sure batteries are oriented properly (see Figure 3).
4.Test range. Temporarily position chime and push button where you want them mounted.
Press push button to verify chime and push button work properly. If chime does not sound, see Troubleshooting.
5.Adjust volume control. Adjust volume control to desired volume (see Figure 3).
© 2008 HeathCo LLC |
