| 6. Mount push button. Use either screws or double |
| sided tape to mount push button. |
| • Screw Mounting: To mount with screws, remove |
| back of case by pushing in tab on bottom with a small |
| screwdriver (see Figure 1). Note: Remove material in |
| screw holes (if needed) before mounting with screws. |
| Attach back of case to door jamb or wall (see Figure |
| 4). Snap front of push button on. |
| • Tape Mounting: When attaching push button using |
| double sided tape, make sure the surface of the door |
| jamb or wall is clean. |
| 7. Mount chime. Chime can be mounted by using 3 |
Figure 4 | holes in the back of case, or by using 2 screws with |
| keyholes. |
Keyhole Mounting: Determine mounting location.
•Mark two hole locations. Note: Make sure holes are level before drilling.
•Models 6153 and 6162 (see Figure 5):
•Models 6171 and 6172 (see Figure 5):
•Drill two 7/32" diameter pilot holes for wall anchors and insert anchors.
•Mount keyhole screws to wall leaving about 1/8" (3 mm) of the screw threads exposed.
•Snap cover onto chime base.
•Models 6153 and 6162: Align top edge of case with top of back plate. Rotate bottom of case toward back plate and snap into position (see Figure 7).
•Models 6171 and 6172: Align bottom edge of case with bottom of back plate. Rotate top of case toward back plate and snap into position (see Figure 7).
•Using keyholes on back of chime base, hang base on screws (see Figure 5).
Screw Mounting: Determine mounting location.
•Place chime against wall and verify the chime is level.
•Use chime holes as a template (see Figure 6). Drill three 7/32" diameter pilot holes for wall anchors (provided) and insert anchors.
•Insert 3 screws (provided) through holes in back of chime.
•Verify chime is level and tighten screws securely.
•Snap cover onto chime base.
•Models 6153 and 6162: Align top edge of case with top of back plate. Rotate bottom of case toward back plate and snap into position (see Figure 7).
•Models 6171 and 6172: Align bottom edge of case with bottom of back plate. Rotate top of case toward back plate and snap into position (see Figure 7).
