Solar Powered Motion Sensor Light
Model 7101
Features
•Turns on light when motion is detected.
•Automatically turns light off.
•Photocell keeps the light off during daylight hours.
•Battery Protection Circuitry. Unit will shut down when battery is low. Unit will automatically resume operation when battery is recharged to a safe level.
Requirements
•Do not turn the light on before the battery is fully charged. Charge the battery by keeping the switch in the OFF position. Plug the solar panel cable into the bottom of the battery case. Point the solar panel directly at the noon sun for 3 sunny days. If not fully charged, the unit will not work.
•When FULLY charged, the solar light will operate a maximum of 15 days without sunlight. Actual operating time will vary depending upon how frequently the light is triggered.
Unpacking
Be sure to remove all contents from packaging and verify all items are present before assembling this light fixture. This package includes the following items:
INSTALLATION
For best performance, mount the fixture about 8 feet (2.4 m) above the ground.
Mounting Holes (3)
Three Mounting Holes for Solar Panel Base
1.Mount solar panel base on a solid surface using three tapered screws. Adjust the panel to point directly at the noon sun. Avoid obstructions such as trees or buildings that may block sun light. Allow for enough wire to reach the case.
Note: You will want to
5 3/4" | Mounting |
Holes (2) |
2.Mount the battery case on a solid surface using two
3.Adjust sensor. For proper operation, the sensor head must be rotated so that the sensor controls face down- ward as shown below.
IMPORTANT: The controls must face downward to avoid damage from rain. If controls face upward, move sensor to the original down position, rotate 180°, then raise to the position shown below.
1. Solar Light Fixture | 2. Solar Panel |
Battery Case
Light
Sensor
3. Mounting Screws (2 sizes)
Light Joint Clamps
Battery Case
Sensor
Sensor Joint 
Clamp
Light
Lens Removal
Tab
Controls
Tapered Screw (3) | Round Head Screw (2) |
© 2008 HeathCo LLC
4.Plug the solar panel cable into the bottom of the battery case. IMPORTANT: Allow the battery to charge with three days of sunshine before testing.
