
BATTERY REPLACEMENT
This solar light contains a rechargeable battery that can be replaced if needed. To replace the battery follow the steps below.
IMPORTANT: The sealed
1.Remove rear battery cover. Press in the two catch releases on the cover and remove the cover.
2.Remove rechargeable battery.Slide battery out of case and remove the wire connectors from the battery.
3.Replace battery. Connect the RED wire connector to the positive (+) terminal and the BLACK wire connector to the negative
4.Replace battery cover.Insert the two tabs on the cover into the slots on the back of the case. Press the cover against the case until the two catch releases snap into place.
IMPORTANT: Keep sensor switch in the “OFF” position for three days to allow the battery to fully charge before testing.
Tab Slots
SPECIFICATIONS
Range | Up to 70 ft. (21 m); [varies with |
| surrounding temperature] |
Sensing Angle | Up to 180° |
LED (x3) | 7.8 watts |
Battery Type | Sealed lead acid, 6 V 6.0 |
On Time | Test, 1 or 5 minutes, selectable |
Full Charge on Time | Up to 1 hour |
IMPORTANT:DO NOT reverse the battery wires.Dam- age to the unit will result. Like any
HeathCo LLC reserves the right to discontinue products and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold.
Rechargeable Battery
Battery
Cover
Positive Wire
Negative Wire
Battery Cover Catch Release