Page 3
TEST AND ADJUSTMENT
❒Turn on the circuit breaker and light switch.NOTE: Sensor has a 12 minute warm up period before it will detect motion. When first turned on or when switching modes wait 12 minutes.
❒Turn the RANGE control to the mid position and the
❒Loosen the clamp screw in the sensor ball joint and gen- tly rotate the sensor.
❒Walk through the coverage area noting where you are when the lights turn on. Move the sensor head up, down, or sideways to change the cov- erage area. Keep the sensor at least 1" (2.5 cm) away from the lamps.
❒Adjust the RANGE as needed. RANGE set too high may increase false triggering.
❒Secure the sensor head's aim by tightening the clamp screw. Do not overtighten the screw.
Clamp
Screw
Ball
Joint
Aim SensorDown for Short
Coverage
Aim Sensor
Higher for LongCoverage
Bottom of Sensor
Avoid aiming the sensor at:❒Set the amount of TIME you want the lights to stay on after motion is detected (1, 5 or 20 minutes).
•Objects that change temperature rapidly, such as heating vents and air conditioners. These heat sources could cause false triggering.
•Areas where pets or traffic may trigger the con- trol.
•Nearby large,
200°
8ft.
(2.4 m)
70 ft. | 100 ft. |
|
(21 m) | (30.5 m) |
|
| Boosted |
|
Maximum Range | Maximum | |
Coverage Angle
The detector is less sensitive to motion directly towards it.
MotionMotion
SPECIFICATIONS
Range . . . . . . . . . . . . Up to 70 ft. (21 m); 100 ft. (30.5 m) with Range Boost. [varies with surrounding temperature]
Sensing Angle . . . . . . Up to 200°
Electrical Load . . . . . . 300 watt Incandescent [150 W each lamp holder].
Power Requirements . 120 VAC, 60 Hz
Operating Modes . . . . TEST, AUTO and MANUAL
MODE
Time Delay . . . . . . . . 1 , 5, 20 minutes
Heath/Zenith reserves the right to discontinue products and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold.
Least Sensitive | Sensor | Most Sensitive |
|
