Mode Switching Summary
| TEST |
|
| ||||
| |||||||
|
|
|
| ||||
|
|
|
|
|
| 5, or 10 minutes | |
|
|
|
|
|
|
| |
| AUTO |
|
|
|
|
| Flip light |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| switch off for |
|
|
|
|
|
|
| one second |
MANUAL MODE |
|
|
| ||||
|
|
| then back on* | ||||
|
|
|
|
|
|
| |
*If you get confused while switching modes, turn the power off for one minute, then back on. After the calibration time the control will be in the AUTO mode.
DualBrite® Dimmer Control
Light comes on half bright for selected time af- ter dusk (Off, 3 hr., 6 hr., until dawn).Selecting OFF disables this feature.The motion sensing features will continue to work as described in this manual. If motion is sensed, the light turns on full bright for the
INSTALLATION
For best performance, mount the fixture about 6 feet (1.8 m) above the ground.
WARNING: Turn power off at circuit breaker or fuse.
SENS
MINMAX
4. Set sensitivity control on back of fixture to
Wire Path
Ground Screw
5.Attach mounting plate to junction box.
This fixture comes with a universal mounting bracket. It is
However, if the slots on the mounting plate do not line up with the junction box screw holes:
1. | Remove the fixture mounting screws from |
| the mounting plate. Note: Do not remove |
| the ground screw. |
2. | Attach ground wire “pigtail” to ground |
| screw on mounting plate (See Recom- |
| mended Grounding Method for additional |
| information). |
1.Remove two nuts.
2.Remove Mounting Plate.
3.Tighten screws finger tight.
3. Flip the mounting plate over. |
