The detector is less sensitive to motion di- rectly towards it and more sensitive to across motion.
MotionMotion
Sensor
Least Sensitive | Most Sensitive |
❒Walk through the coverage area noting where you are when the lights turn on. Move the sensor head left or right to change the coverage area.
Note: Grasp the sensor only as shown and turn the entire sensor. Any other method may damage the sensor. Do not force it past the stops.
SPECIFICATIONS
Range | Up to 30 ft. (9.1 m) | |
| [varieswithsurrounding | |
| temperature] | |
Sensing Angle. . . | Up to 150° | |
Electrical Load. . . | Up to | 100 Watt |
| Maximum Tungsten | |
| Incandescent | |
Sensor Capacity . . | Upto360Watts(3.0A.) | |
| Maximum Tungsten | |
| Incandescent | |
Power Requirements 120 VAC, 60 Hz | ||
Operating Modes. . | TEST, | AUTO, and |
| MANUAL MODE | |
Time Delay . . . . | 1, 5, 10 minutes | |
DualBrite® Timer. . | Off, 3, 6 hours, | |
| dawn |
|
HeathCo LLC reserves the right to discontinue products and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold.
240° | Sensor Aiming |
| |
| Adjustment Angle |
❒If you need to change the sensitivity, temporarily remove the fixture and make the adjustment.Too much sensitivity may increase false triggering.
❒Set the amount of TIME you want the light to stay on after motion is detected. (1, 5, or 10 minutes).
❒Set the amount of time after dusk you want the lights on accent level.
