Heath Zenith PF-4192-WH, PF-4197-WH warranty Testing, Turn on the circuit breaker and light switch

TESTING

❒Turn on the circuit breaker and light switch.

Note: Sensor has a 1 1/2 minute warm up pe- riod before it will detect motion.When first turned on wait 1 1/2 minutes.

Note: Meets the ENERGY STAR® guidelines when DualBrite® function is off.

❒Switch the on-time to TEST position and DualBrite® switch to the OFF position.

The detector is less sensitive to motion di- rectly towards it and more sensitive to across motion.

MotionMotion

	Sensor
Least Sensitive	Most Sensitive

TEST 1 5 10 MIN	OFF 3 6 DUSK TO
ON-TIME	HOUR DAWN

Avoid aiming the control at:

•Pools of water or objects that change temperature rapidly, such as heating vents and air conditioners. These heat sources could cause false triggering.

•Areas where pets or traffic may trigger the control.

•Nearby large, light-colored objects reflecting daylight may trigger the shut-off feature. Do not point other lights at the sensor.

❒Walk through the coverage area noting where you are when the lights turn on.

❒If you need to change the sensitivity, temporarily remove the fixture and make the adjustment. Too much sensitivity may increase false triggering.

❒Set the amount of TIME you want the light to stay on after motion is detected. (1, 5, or 10 minutes).

❒Set the amount of time after dusk you want the lights on accent level.

180°

6 ft.

(1.8 m)

30ft.

(9.1 m)

Maximum Range	Maximum
	Coverage Angle

598-1167-05