Heath Zenith PF-4197-WH, PF-4192-WH, PF-4192-BK warranty Specifications, Troubleshooting Guide

SPECIFICATIONS

Range . . . . . . Up to 30 ft. (9.1 m) [varies with surrounding temperature].

Sensing Angle. . . Up to 180°

Electrical Load. . . See rating on fixture for maximum wattage.

Sensor Capacity . . Up to 360 Watt (3.0 A.) Maximum Tungsten Incandescent

Power

Requirements . . . 120 VAC, 60 Hz Operating Modes. . TEST, AUTO, and

MANUAL MODE Time Delay . . . . 1, 5, 10 minutes DualBrite® timer . . Off, 3, 6 hrs, Dusk-to-

Dawn

HeathCo LLC reserves the right to discontinue products and to change specifications at any time without incurring any obligation to incorpo- rate new features in products previously sold.

TROUBLESHOOTING GUIDE

SYMPTOM	POSSIBLE CAUSE
Light will not	1.	Light switch is turned off.
come on.	2. Bulb is loose or burned out.
	3.	Fuse is blown or circuit breaker
		is turned off.
	4.	Daylight turn-off is in effect
		(recheck after dark).
	5.	Incorrect circuit wiring, if this is
		a new installation.
Light comes on	1. Light control may be installed
in daylight.		in a relatively dark location.
	2.	Light control is in Test. (Set
		control switch to an ON-TIME
		position.)

SYMPTOM	POSSIBLE CAUSE
Light comes	1. Light control may be sensing
on for no ap-		small animals or automobile
parent reason.		traffic (Reduce sensitivity).
Light stays on	1. The sensor is pointed toward
continuously.		a heat source like an air vent,
		dryer vent, or brightly-painted
		heat-reflective surface.(Reduce
		sensitivity.)
	2.	Light control is in Manual Mode.
		(Switch to Auto.)
	3.	Light control is in DualBrite®
		mode.
	4.	Sensitivity is set too high. (Re-
		duce sensitivity.)
Light flashes	1.	Light control is in the Test
on and off.		mode and war ming up.
		(Flashing is normal under these
		conditions).

598-1167-05