INSTALLATION
For under eave installation, the sensor head must be rotated as shown in the next two steps for proper operation and to avoid the risk of elec-
❒After screwing the sensor into the wall plate, connect the junction box wires to the light control wires by twisting together and securing with wire connectors.
trical shock.
For eave mount only:
❒Swing the sensor head towards the clamp
screw.Controls Clamp Screw
White to White
Junction
Box
Red Sensor Wire to
Black Lamp Wire
Lamp
Holders
❒Rotate the sensor head clockwise 180° so the controls face down.
Controls
Controls
If the sensor pops out of the ball joint, loosen the clamp screw and push the sensor back into the ball joint. Tighten the clamp screw when done.
These instructions show the sensor wired to flood- lamps.The white sensor wire is neutral.The black sensor wire is hot. The red wire is the switched "hot" wire. The lighting load (500 W, 4.2A max) is placed across the white and red wires.
Wire the Light Control
WARNING: Turn power off at the fuse or circuit breaker.
❒Remove the existing light fixture, if present.
Black to Black
Optional: Connect additional load across the white and red wires. Total lighting load including lampheads on fixture must not exceed 500W (4.2A).
Mount the Light
❒Follow the instructions that came with your light fixture for mounting and adjusting the light fix- ture.
❒Keep regular
- - |