Label
Covers
Labels Label Push Buttons
Using a small flat head screw- driver or fingernail, carefully pry off the label covers on the front of the push button. Remove and write relevant information on labels. Replace label covers.
Troubleshooting
Chime does not sound:
•Make sure push button and chime codes are the same (See pages 3, 4, and 5).
•Check orientation of push button battery (See page 5).
•Check charge of push button and chime batteries (if ap- plicable), replace if necessary.
Batteries seem OK, but the chime does not work when installed:
•Do not mount chime or push button on metal or near metal studs. This reduces the transmitter range. Use 1/4" to 1/2" (6 to 13 mm) wood shims to move chime or push button off metal surface.
•Concrete floors may reduce range. Move chime away from floor.
•Try locating chime closer to push button.
The range of the wireless chime can vary with location, tem- perature and battery condition.
- - |
