Heath Zenith SL-7001 manual Battery Replacement, Specifications

BATTERY REPLACEMENT

This solar light contains a rechargeable battery that can be replaced if needed. To replace the battery follow the steps below.

IMPORTANT: The sealed lead-acid battery must be recycled or disposed of properly.

1.Remove rear battery cover. Press in the two catch releases on the cover and remove the cover.

2.Remove rechargeable battery.Slide battery out of case and remove the wire connectors from the battery.

3.Replace battery. Connect the RED wire connector to the positive (+) terminal and the BLACK wire connector to the negative (-) terminal.

4.Replace battery cover.Insert the two tabs on the cover into the slots on the back of the case. Press the cover against the case until the two catch releases snap into place.

IMPORTANT: Keep sensor switch in the “OFF” position for three days to allow the battery to fully charge before testing.

Tab Slots

Positive Wire Negative Wire

Battery

Cover

Rechargeable

Battery

Battery Cover Catch Release

SPECIFICATIONS

Range	Up to 60 ft. (18.3 m); [varies with
	surrounding temperature]
Sensing Angle	Up to 110°
Lamp	15 watt, 6 volt halogen
Battery Type	Sealed lead acid, 6 V 6.0 A-Hr.
On Time	30 seconds, re-triggerable
Full Charge on Time	Up to 1 hour

IMPORTANT:Replace lamp only with same type lamp, 20 watts or less. DO NOT reverse the battery wires. Damage to the unit will result. Like any lead-acid battery, this battery must be disposed of properly.

DESA Specialty Products™ reserves the right to dis- continue products and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold.

595-5291-07 3