Henkel 97050, 97051

Warning!

Refers to safety regulations and requires safety measures that protect the

operator or other persons from injury or danger to life.

– UVA Hand Lamp with ballast /wall power supply 97050 (UK version

97051)

– Operating Manual

 As a result of technical development, the illustrations and descriptions in

this operating manual can deviate in detail from the actual unit delivered.

For safe and successful operation of the unit, read these instructions

completely. The manufacturer cannot be held responsible for damage or

injury of any kind because of misuse or improper application or because of

failure to observe safety instructions or warnings.

Be sure to retain this manual for future reference.

Get a technical data sheet for the LOCTITE product used at

www.loctite.com.

Use the lamp only in dry locations where no explosion hazard exists.

Switch off after use.

Only an authorized service center representative, except changing

the bulb, may repair the unit.

Damage to the power cord or the housing can result in contact with

live electrical parts.

Check the power cord and the unit before each use.

If the power cord or the unit is damaged, do not operate!

Replace a damaged power cord with a new one.

Observe general safety regulations for the handling of chemicals!

Observe manufacturer’s instructions!

Request a safety data sheet for the LOCTITE-product used!

The UVA Hand Lamp generates intensive UV radiation that, with

direct exposure, can damage skin and eyes in a short time.

Avoid direct radiation of the skin and eyes under all circumstances!

Wear UV protective glasses and protective gloves in all cases!

Special lamp for mobile use, for curing UV and light curable adhesives and

coatings. Because of low intensity, tack-free surfaces cannot be achieved

in most cases.

Use only in dry locations where no explosion hazard exists!

UV UV