Thermostat Calibration, Recommended Spare Parts

THERMOSTAT CALIBRATION

1.Turn on unit. Set control dial at desired temperature.

2.Allow control to cycle at least three times (3) and observe temperature at the middle of the fourth cycle.

3.If calibration is required, carefully remove dial knob. Do not turn shaft.

4.Turn calibration screw in center of dial shaft clockwise to lower temperature and counter-clockwise to increase temperature.

5.Allow unit to cycle three (3) times and observe temperature at middle of fourth cycle. Readjust calibration screw if necessary. Replace dial knob.

When it is critical to have continuous operation of this unit, we suggest having the following spare parts on hand:

1.Heating Element

2.Thermostat

3.Power Cord

Sensor

Thermostat

# 301037

Oven Ground

- 6 -