Adjusting the Airflow Direction
1. Horizontal
!CAUTION
2.Vertical
The horizontal airflow can be adjusted by moving the vertical vanes wit your hands to the left or right.
When the humidity is high, the vertical vanes should be in the front
position during the cooling or dehumidifying operation. If the vertical vanes are positioned all of the way to the right or left, condensation may begin to form around the air vent and drip down.
The vertical airflow can be adjusted by moving the flap with the remote control unit has been turned on. Then, use the FLAP button to set either the sweep function or one of the six airflow direction settings.
|
|
|
|
| 6 |
|
FLAP |
|
| MODE | COOL | 5 |
|
|
|
|
| and | 4 |
|
ON | OFF | FAN |
| DRY |
| |
|
|
| ||||
|
| SPEED |
|
| 3 |
|
|
|
|
|
|
| |
SET | CLR | SOFT | SLEEP | SWEEP | 2 | 1 |
|
|
|
| HEAT | ||
BATTERY | A/C SENSOR | ACL |
| |||
|
|
|
| |||
A.Sweep function
The flap starts moving up and down to
deliver air over the sweep range.
B.Automtic Function
The flap moves up and down automatically
from | to | during the cooling or drying | |
operation, from | to | duing the heating | |
operation. Referring to the above illustration.
!
!
NOTE
CAUTION
¡ñThe flap automatically closes when the unit is off.
¡ñUse the FLAP button on the remote control to adjust the position of the flap.
If you move the flap by hand, the flap position according to the remote control and the actual flap position may no longer match.If this happens,shut off the unit, wait for the flap flap to close, and then turn on the unit again; the flap position will now be normal again.
¡ñDo not have the flap pointed down during cooling operation. Condensation
May begin to from around the air vent and drip down.
11 
