Hitachi 231327 manual Reassembly

Reassembly

1.Install the clutch housing (2), capscrews (8) and lockwashers (9) on the engine. See Fig. 18.

2.Install the engine shaft key (13). See Fig. 18.

3.Press the clamp (3) onto the engine shaft (A). Maintain the 1.99 "0.01 in. (50.55 "0.25 mm) dimension shown in Fig. 19.

To check the dimension, place a rigid, straight steel bar (B) across the face of the clutch housing

(2). Use an accurate measuring device to measure the distance between the bar and the face of the clamp. Adjust the clamp as necessary. Torque the two screws (16) to 125 "10 in-lb (14 "1.1 N￿m).

4.Connect the wires of the wire harness (96) to the screws (98) in both places on the field (wires can be attached to either connection). Pull the plastic caps (C) up and snap them over the screws. Install the field (6) in the clutch housing (2). Work the wire harness through the slot in the clutch housing, With the setscrew holes in the field and the clutch housing (2) aligned, tighten the setscrews (12) oppositely and evenly, to 27 "3 in-lb (3.1 "0.3 N￿m). See Fig. 18.

Torque the screws oppositely and

1evenly to 27 "3 in-lb (3.1 "0.3 N￿m).

2Slot.

13

112

9

8

3

A

	2
	2
	16
	6
	C 96
	98
Fig. 18	03482

1The face of the housing.

21.99 "0.01 in. (50.55 "0.25 mm).

3Torque the screws to 125 "10 in-lb (14 "1.1 N￿m)

1 2

2

B

16 3

Fig. 19 03483

5.Place the engine (1) assembly on the cart. Align the mounting holes. Carefully guide the engine wire (D) and wiring harness (96) from the field, through the appropriate grommets (66) in the mounting plate (E). Install the flange screws (14) and locknuts (111). Torque to 15 ft-lb (20.4 N￿m). Install the capscrew (15), lockwasher (80) and washer (99) from under the engine mounting plate to the clutch housing (2). Connect the engine wire

(D) to the red wire, and connect the black and white wires as shown in the Detail drawing in Fig. 20.

24 308398