Hitachi 42HDM12A Front Panel Controls, 42” PLASMA MONITOR, ① REMOTE CONTROL sensor

FRONT PANEL CONTROLS

FRONT VIEW

42” PLASMA MONITOR

①REMOTE CONTROL sensor

Point your remote control at this area when selecting signal, adjusting volume, etc.

②POWER light indicator

To turn the PDP MONITOR ON, press the main power button located on the BACK left side of the monitor. A red stand-by indicator lamp located on the lower right corner of the front bezel will illuminate. The PDP monitor is now ready for remote on/off operation.

Indicating Lamp

Off

Lights Red

Lights Orange

Lights Green

Power Status	Operating
Off	When the MAIN POWER is set OFF.
Off (Stand-by)	When the MAIN POWER is set ON and the Front Key or
	Remote Control POWER is OFF.
Off (Power Saving)	1.	When the MAIN POWER is set ON.
	2.	No signal input (no sync. signal).
On	When the POWER is ON.

③POWER button

This power button is for power on the plasma monitor or change to standby mode.

④▼ and ▲ selector

These buttons serve as the cursor down (▼) and up (▲) buttons when in MENU mode.

⑤VOLUME level

Press these buttons to adjust the sound level. The volume level will be displayed on the monitor screen. These buttons also serve as the cursor left (W) and right (X) buttons when in MENU mode.

⑥INPUT/EXIT button

Press this button to select the desired input: Composite-VIDEO, S-VIDEO, YCBCR, YPBPR, Analog RGB or HDMI source. This button also serves as the EXIT button when in MENU mode.

⑦MENU/SELECT button

This button allows you to enter the MENU, making it possible to set monitor features to your preference without using the remote. This button also serves as the SELECT button when in MENU mode.

12