Hitachi 42PMA300A user manual AV1, AV2 AV3, AV4

OPERATING INSTRUCTIONS (continued)

SETUP MENU

MENU

Picture

Audio

Timer

Function

Setup

Language

Select

OK Set

	Setup				Setup
		System	System 1			Color System
OK				OK
		Color System
		Video Input				AV1	Auto
		Audio Input				AV2	PAL
		Scart Output	Monitor			AV3	SECAM
		RGB1	DVI-STB			AV4	PAL
		RGB2	Component
			HDTV
		Select OK Set	Return			Select	Return	Exit

Setup				Setup
	System	System 1			Video Input
	Color System		OK
					AV1	Auto
	Video Input
	Audio Input				AV2	Composite/Component
	Scart Output	Monitor			AV3	Auto
	RGB1	DVI-STB			AV4	S.Video
	RGB2	Component
		HDTV
	Select OK Set	Return			Select	Return	Exit

Setup				Setup
	System	System 1			Audio Input
	Color System		OK		AV1		Stereo
	Video Input				AV2		L/Mono
	Audio Input				AV3		Stereo
	Scart Output	Monitor			AV4		L/Mono
	RGB1	DVI-STB			Select	Return		Exit
	RGB2	Component
		HDTV
	Select OK Set	Return

Selected characters										Setup hint
System				System1				System2		Do not change the original setting.
										(System1 : Europe/Asia, System2 : North America)
Color System
										This should correspond to the color system of the signal from the
										equipment that is connected to AV1 video input terminal.
		Auto				PAL			SECAM	• Normally, set this to Auto. The system of the input signal will be
AV1										automatically recognized.
			NTSC3.58					NTSC4.43		• If the input signal contains much noise or has a low level at Auto and the
										operation is found erratic, set this to match the input signal.
										• When the component signal is received, this would be not available
										(grayed out).
AV2
AV3										(Same to AV1)
AV4
Video Input
										This should correspond to the signal mode of the signal from the
										equipment that is connected to AV1 video input terminal.
AV1	Auto				HDTV				SDTV/DVD	• Normally, set this to Auto. The signal mode of the input signal will be
										automatically recognized.
										• If the input signal contains much noise or has a low level at Auto and the
										operation is found erratic, set this to match the input signal.
AV2 (1st step)	RGB				Composite/Component					This should correspond to the signal mode of the signal from the
										equipment that is connected to AV2 video input terminal.
AV2 (2nd step)	Auto				HDTV				SDTV/DVD	This step should be set only when [Composite/Component] is selected on
										the 1st step. And the procedure is same to AV1.
										• If the signal from the equipment that is connected to AV4 Scart input
AV4				S.Video			Composite			terminal is S.Video or Composite, set this to correspond to that signal.
										• If the signal is RGB, it will be automatically recognized and this setting
										will have no effect.