35
USING YOUR REMOTETO CONTROL ADDITIONAL AUDIO EQUIPMENT
Operating the precoded function for your Audio component.
This remote is designed to operate different types of Audio component. You must first program the remote to match the remote system
of your Audio component (refer to page 36 for pre-codes).
1. Turn ON your Audio component you wish to control with the Remote.
2. Aim the remote control at the front of your Audio component.
3. Press and release the CD or AMPbutton (Audio buttons) to switch to Audio component pre-coded mode.
4. Hold down the CD or AMPbutton on the remote and enter the two digit preset code that matches your Audio component, as shown
on page 36. The indicator light will flash 3 times if the code was accepted.
5. Aim the remote at the Audio component and press the POWERbutton. The remote will turn off your Audio component when the
correct two digit preset code is entered. When this occurs, the remote control is programmed for your Audio component. If the
Audio component does not turn off, try a different two digit preset code.
6. The remote will now control your Audio component.
7. Repeat steps 1 - 6 if you wish to program the remote to control another Audio component. Be sure to use a different Audio button
on the remote, since only one component can be programmed per button.
NOTES:
1. If your Audio component cannot be operated after
performing the above procedures, your Audio
component’s code has not been precoded into the
remote.
2. In the unlikely event that your Audio componentcannot be
operated after performing the above procedures, please
consult your Audioequipment operating guide.
3. The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control. After replacing the batteries repeat the
entire programming procedure as stated above.
CD and AMPButtons
These buttons allow the remote to control your Audio
equipment by setting it to Audio mode.
PRECODED AUDIO Buttons
These buttons transmit the chosen precoded Audio
component codes.
EXCLUSIVE TV Buttons
These buttons are for operating the TV.
POWER
TV VCR CBL
AUX
12
456
3
789
0
INFO
SLEEP
10+
DVD
EXIT
MENU
CHVOL
MUTE
SOURCE WIZARD
REC
SELECT
VIRTUAL HD
ASPECT
STB
ANT
LAST CH
VID 1
VID 2
VID 3
VID 4
VID 5
PVR
CD AMP
C.C.
NAVI DISC MENU ADVANCED
ZOOM
DAY/NIGHT
PIP SURF FRZ
MODE SWAP
SUB TITLE

MY AUDIO EQUIPMENT CODE IS:

NOTE: Refer to instruction manual of the Audio equipment for operation of the buttons exclusively for the Audio equipment.

CD

AMP/RCVR