USING THE REMOTE TO CONTROL CABLE BOX FUNCTIONS

- 24 -

USING THE REMOTE TO CONTROL CABLE BOX FUNCTIONS

Operating the pre-coded function for your cable box

This remote is designed to operate different types of cable boxes. You must first program the remote to match the remote system in your cable box. (Refer to page 22)

1.Turn ON your cable box.

2.Aim the remote control at the front of your cable box.

3.Press the CABLE button to switch to the the cable box precoded mode.

4.While holding down the SELECT button, enter the 2 digit preset code that matches your cable box as shown on page 22. The remote will turn off your Cable Box when the correct 2 digit preset code is entered. When this occurs, the remote control is programmed for your cable box. If the cable box does not turn off after 5 seconds, try another 2 digit preset code.

5.The remote will now control your cable box.

NOTES:

1.If your cable box cannot be operated after performing the above procedures, this means that your cable box codes have not been precoded into the remote.

2.In the unlikely event that your cable box cannot operate after performing the above procedures, consult your cable box operating guide.

3.The remote control will remember the codes you have programmed in until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure stated above.

4.If your cable box does not have a power function, the remote will issue the CHANNEL UP function.

Remote Control Buttons

￿ CABLE BUTTON

This button allows the remote to control your cable box by setting it to CABLE mode.

￿ SELECT BUTTON

This is for setting up the remote to transmit the cable box's remote codes.

￿ PRECODED CABLE BOX BUTTONS

These buttons transmit the chosen precoded CATV codes.

￿ TV/VCR BUTTON

When the remote is in CABLE mode, this is the A/B button.

￿ ENTER BUTTON

If your cable box does not have an enter function, this button will send the TV enter code.