ADDITIONAL BLADE ADJUSTMENTS (Fig. I)

1.If the front and rear measurements are not the same, remove the combination square and loosen the four adjusting screws (1) on the top of the table about a half turn.

2.With a folded piece of cardboard covering the blade to protect your hands, move the blade and motor mounting rod carefully to the left or right as much as needed to align the blade correctly.

3.Tighten the four screws (1) and re-measure, as described in steps 4 to 9 in the prior section.

4.If sufficient adjustment cannot be made by the four adjusting screws (1), then also loosen the two adjusting screws (2) and repeat all previous steps. Loosen these screws only if necessary at they are set for accurate 90° and 45° settings.

5.Recheck blade clearance making sure that the blade does not hit the table insert or other parts when at the 90° and 45° settings.

6.Re-tighten all four adjusting screws (1) and reset the 90° and 45° setting as stated on page 13.

Fig. I

1

2

INSTALLING THE PUSH-STICK STORAGE (FIG. J) Attach the push-stick storage (1) into the right side of the body shell.

Fig. J

3

4

1

English

STORAGE (FIG. J, K)

Rip fence and miter gauge (Fig. J)

Storage brackets for the rip fence (3) and miter gauge

(4)are located on the right side of the saw housing. NOTE:Adjust the miter gauge to 450~600 before putting to the storage.

Blade (Fig. K)

1. Loosen and remove the knob (1) on the left side of the saw housing.

2. Place extra blades onto the arbor. Replace the knob and tighten.

Fig. K

1

INSTALLING THE TABLE INSERT (FIG. L)

WARNING

The table insert has been previously installed on your unit. However, you must verify that the table insert is flush with the table top surface on all four corners of the insert.

To aviod serious injury , the table insert must be level with the table.If the table insert is not flush with the table, adjust the four bolts (1) with a 4

mmhex. wrench until it is parallel with the table. NOTE: To raise the insert , turn the hex screws counterclockwise, to lower the insert, turn the hex screws clockwise.

1.Replace the table insert by pulling out the hold (2) of the table insert.

1

Fig. L

2

– 15 –

Page 15
Image 15
Hitachi C 10RB Additional Blade Adjustments Fig, Storage FIG. J, K, Rip fence and miter gauge Fig. J, Blade Fig. K