0.6mm 
Fig. 32
NOTE
In some areas, local law requires using a resistor spark plug to suppress ignition signals. If this machine was originally equipped with resistor spark plug, use same type of spark plug for replacement.
Flexible drive shaft (Fig. 33)
Flexible drive shaft should be removed and lubricated with good quality lithium grease every 20 hours. To remove the flexible shaft, first remove screw (29), loosen bolt (30) and remove the gear case then pull the shaft out of the drive shaft pipe. Clean the shaft off and apply a generous coat of lithium grease to it and insert if back into the drive shaft pipe, turn it unit it drops into place then install the gear case, install & tighten screw (29) and screw (30).
30
29
For CG22EAB(SL)
Fig. 33
Angle transmission (Fig. 34)
Check angle transmission or angle gear for grease level about every 50 hours of operation by removing the grease filler plug on the side of angle transmission.
If no grease can be seen on the flanks of the gears, fill the transmission with quality lithium based multipurpose grease up to 3/4. Do not completely fill the transmission.
Fig. 34
Nylon line replacement
(1) Remove the case (31) by firmly pushing inward the locking tabs with your thumbs as shown in Fig. 35.
31
Fig. 35
(2)After removing the case, take out the reel and discard the remaining line.
(3)Fold the new nylon line unevenly in half as shown in picture. Hook the
Wind both halves of the line on the reel in the same direction, keeping each half of the line on its own side of the partition. (Fig. 36)
10 cm
32
Fig. 36
(4)Push each line into the stopper holes (33), leaving the loose ends approx. 10 cm in length. (Fig. 37)
10 cm
cm | 33 |
| |
10 |
|
Fig. 37
(5)Insert both loose ends of the line through the cord guide (34) when placing the reel in the case. (Fig. 38)
33
34
Fig. 38
NOTE
When placing a reel in the case, try to line up the stopper holes (33) with the cord guide (34) for easier line release later.
13